If any device has a signal below -75, the device will tell the controller the signal is low and report this information by displaying the word “Lo” and “Ant” followed by the signal value, device address, and device channel. *Er will display on the upper 7-segment display and the number 50 will show on the lower display. To fix this, you will need to Force Unsync your 18R2 at which time the address counter will reset to A00 and you re-sync your devices. Once you exceed A199, this error will display. In 5.0 and lower, there is a 200 device address limit. The maximum amount of unique module addresses is met. Re-start your 18R2 and the firmware version should be correct.Įr50 (Error 50) - Maximum addresses reached This will spin the LEDs and go fully green and then power off when complete. At this point in time, you would proceed to the next step and load the cobra.s19 file to your USB drive, place into the 18R2 while off, then hold the SYNC button and power on the 18R2 at the same time.
When performing a firmware update on the 18R2, it's normal to see Er6 when you update the firmware on the transceiver first.
The first is the transceiver and the second is the processor.
The 18R2 has two internal chips that require firmware updates. csv files on it and that the COBRA script you are trying to load has the word end on the last line of the script.Įr6 (Error 6) - Transceiver firmware does not match processor firmware Please make sure your USB drive has no other. Your script upload failed / you don’t have the word “end” on the last line of your script file or you have a non-COBRA.
Make sure that no buttons are being pressed or stuck during the boot-up process. or lower, only the device channel will display and not the address.Ī button is pressed while the module was powering on. If any device has a signal above -75, the device will tell the controller the signal is low and report this information by displaying the word “Lo” and “Ant” followed by the signal value, device address, and device channel.